[. . . ] Service for your Kettle Contact the dealer from whom you purchased your appliance. Sørg for at der ikke kommer for tykke lag kedelsten i kedlen, da dette vil gøre den mindre effektive og kunne bevirke, at sikkerhedsafbryderen slukker for tidligt for kedlen. [. . . ] Always use fresh water for each usage and discard any boiled water that is not used. Remember is it not economical to boil more water that you need but you should always check that there is water covering the element before you switch on. Warning: If the kettle is overfilled there is a risk that boiling water may be ejected. Note: Before normal use it is recommended that the kettle is filled, boiled and the water discarded. Place the filled kettle on a level surface, insert the connector and plug into the mains supply. The kettle will automatically switch off a few seconds after the water has boiled. Cleaning and Care Remove the plug and the power supply cord from the socket outlet before cleaning. In certain areas furring or lime deposits will form on the heating element which will result in increased boiling times and can effect the kettle operation. If this deposit is not removed it can cause permanent damage to the kettle. The scale can be removed by using an appropriate descalent available from most leading supermarkets, department and hardware stores or chemists. After descaling, the kettle should be boiled with fresh water several times before use. Excessive use of descalents should be avoided as this may shorten the life of the kettle element. [. . . ] Excessive use of descalents should be avoided as this may shorten the life of the kettle element. Ensure that the exterior of your kettle is thoroughly cleaned to remove any traces of descalent, failure to do so may damage your kettle. [. . . ]